AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P1000 2009 Ford Fusion

P1000 2009 Ford Fusion Code - On Board Diagnostic System Readiness Test Not Complete

- Code Popularity: 7,094 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1000 2009 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • The vehicle is new from the factory.
  • Battery or Powertrain Control Module (PCM) had recently been disconnected.
  • An OBD monitor failure occurred before completion of an OBD drive cycle.
  • PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool.
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P1000 2009 Ford Fusion?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

This code just means that the Powertrain Control Module (PCM) didn't complete a full diagnosis cycle, and is set when the battery has been disconnected, codes have been cleared, or sometimes even when the vehicle has been towed. No scanner is necessary to clear the code, driving the vehicle for a few minutes (sometimes more) to complete the diagnosis cycle will clear the code. Clearing the code will reset the light unless other codes are present.

Search for P1000 2009 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1000 2009 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P1000 2009 Ford Fusion Description

The On-Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check. If Diagnostic Trouble Code (DTC) P1000 is triggered after DTCs have been cleared, all engine management OBD diagnostic monitor drive cycles have not been cleared.

OBDII Code P1000 2009 Ford Fusion - On Board Diagnostic System Readiness Test Not Complete - AutoCodes.com
P1000 2009 Ford Fusion Code - On Board Diagnostic System Readiness Test Not Complete

Need More Information on the Code?

Need more information on how to fix the P1000 2009 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1000 2009 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Code P1000 2009 Ford Fusion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1000 2009 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks