P0868 DODGE - Line Pressure Low
- Faulty Line Pressure Sensor
- Plugged Transmission Oil filter
- Stuck or Sticking Main regulator Valve
- Faulty Transmission Oil Pump
2005-2006 (DR) Ram Truck
2005-2006 (HB) Durango
2005-2006 (ND) Dakota
Dodge Factory Service Bulletin OBDII Code P0868
- Delay of shifting
Line pressure is measured by the Line Pressure Sensor (LPS) and regulation is achieved by changing the duty cycle of the Pressure Control Solenoid (PCS) controlled by the Transmission Control System. (5% duty cycle = solenoid off = Max line pressure, 62% duty cycle = solenoid on = Min line pressure). The Transmission Control System calculates the desired line pressure based on inputs from both the engine and transmission.
The Transmission Control System calculates torque input to the transmission and uses it as the primary input to the desired line pressure calculation. This is called Torque Based Line Pressure. In addition, the line pressure is set to a preset level 827 or 931kPa (120 or 135 psi) during shifts and in Park and Neutral to ensure consistent shift quality. The actual line pressure is continuously being compared to the desired (target) line pressure.
my check engine light comes on and then goes out after a couple of starts. the code it gave out is ...
I Have thefault code p0868 only 2010 dodge grand caravan 3.8L...
what does code po868 mean on this vehicle....
no power i need information...
Any information is appreciated. Thanks