AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0731 Ford

P0731 Ford Code - Incorrect First Gear Ratio

- Code Popularity: 66,994 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0731 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low transmission fluid level
  • Dirty transmission fluid
  • Shift solenoids
  • Transmission mechanical problems
  • Transmission hydraulic control circuit
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0731 Ford?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Start by inspecting the transmission fluid level and condition, and change fluid if necessary.





User Submitted Video

Search for P0731 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0731 Ford code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Transmission in first gear and the ECM detected an incorrect gear ration

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Incorrect transmission shifting

Code P0731 Ford Description

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (1st) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

OBDII Code P0731 Ford - Incorrect First Gear Ratio - AutoCodes.com
P0731 Ford Code - Incorrect First Gear Ratio

Need More Information on the Code?

Need more information on how to fix the P0731 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0731 Ford code diagnosed by a professional: Find a repair shop in your area

Code P0731 Ford comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0731 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks