AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Hyundai - P0730 Hyundai

P0730 Hyundai Code - Incorrect Gear Ratio

- Code Popularity: 17,800 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0730 Hyundai?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low transmission fluid level
  • Dirty transmission fluid
  • Shift solenoids
  • Transmission mechanical problems
  • Transmission hydraulic control circuit
⚠ Does your Hyundai have Safety Recalls? → Check here

How to Fix the DTC P0730 Hyundai?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Start by inspecting the transmission fluid level and condition, and change fluid if necessary.

Search for P0730 Hyundai Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0730 Hyundai code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The TCM has detected that the transmission is trying to mechanically shift to a lower gear than intended

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Incorrect transmission shifting

Code P0730 Hyundai Description

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from speed sensor (revolution sensor)
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

OBDII Code P0730 Hyundai - Incorrect Gear Ratio - AutoCodes.com
P0730 Hyundai Code - Incorrect Gear Ratio

Need More Information on the Code?

Need more information on how to fix the P0730 Hyundai code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0730 Hyundai code diagnosed by a professional: Find a repair shop in your area

Code P0730 Hyundai comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0730 Hyundai code? Have you replaced any parts?
Any information is appreciated. Thanks