AutoCodes.com | All About OBDII Engine Codes
AutoCodes - GMC - P0562 GMC

P0562 GMC Code - System Voltage Low

- Code Popularity: 9,776 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0562 GMC?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low battery charge
  • Battery defective
  • Loose or missing alternator drive belt
  • Faulty alternator
  • Open or short system voltage circuit
⚠ Does your GMC have Safety Recalls? → Check here

How to Fix the DTC P0562 GMC?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Start by recharging or replacing the battery.

Search for P0562 GMC Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0562 GMC code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Slow engine start
  • Low battery power

Code P0562 GMC Description

The Powertrain Control Module (PCM) continuously monitors the system voltage. The system voltage information is taken from the PCM's ignition feed circuits. Voltages below 8.0 volts or above 17.1 volts cause improper system operation and/or component damage. If the system voltage is low the PCM raises the idle speed in order to increase the generator output. The PCM disables most outputs to protect the hardware if the system voltage is high. A scan tool may not display data if system voltage is outside this range. The Diagnostic Trouble Code (DTC) will be set if the PCM detects a too low electrical system voltage level.

OBDII Code P0562 GMC - System Voltage Low - AutoCodes.com
P0562 GMC Code - System Voltage Low

Need More Information on the Code?

Need more information on how to fix the P0562 GMC code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0562 GMC code diagnosed by a professional: Find a repair shop in your area

Code P0562 GMC comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0562 GMC code? Have you replaced any parts?
Any information is appreciated. Thanks