AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0460 2012 Ford Fusion

P0460 2012 Ford Fusion Code - Fuel Level Sensor 'A' Circuit

- Code Popularity: 4,221 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0460 2012 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Fuel Level Sensor
  • Fuel Level Sensor harness is open or shorted
  • Fuel Level Sensor circuit poor electrical connection
  • Faulty combination meter
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0460 2012 Ford Fusion?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

For some Ford vehicles.

SERVICE PROCEDURE
P0460 can be caused by the installation of aftermarket equipment such as remote starter systems and auxiliary fuel tanks.

Ford offers a remote starter system which is recommended. If the vehicle has an aftermarket remote starter system, it would need to be removed / disabled before diagnostics for P0460 can be started. Auxiliary fuel tanks that continuously replenish the vehicles main tank will cause a P0460. Customers that replenish the vehicles fuel tank from the auxiliary fuel tank while the key is on and engine is running, can set P0460. For vehicles with an auxiliary fuel tank, it is recommended not to use the gravity / continuous fill style auxiliary fuel tanks. It is recommended to add fuel to the vehicles main tank with the key off.

NOTE: P0460 CAUSED BY AFTERMARKET EQUIPMENT/VEHICLE MODIFICATIONS IS NOT COVERED UNDER WARRANTY.

Search for P0460 2012 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0460 2012 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Even though the vehicle is parked, a signal being varied is sent from the fuel level sensor to Engine Control Module (ECM).

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Fuel level gauge improper operation

Code P0460 2012 Ford Fusion Description

The fuel level sensor is mounted in the fuel level sensor unit. The sensor detects a fuel level in the fuel tank and transmits a signal to the Engine Control Module (ECM). The fuel level sensor consists of two parts, one is mechanical float and the other side is variable resistor. The fuel level sensor output voltage changes depending on the movement of the fuel mechanical float.

OBDII Code P0460 2012 Ford Fusion - Fuel Level Sensor 'A' Circuit - AutoCodes.com
P0460 2012 Ford Fusion Code - Fuel Level Sensor 'A' Circuit

Need More Information on the Code?

Need more information on how to fix the P0460 2012 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0460 2012 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Code P0460 2012 Ford Fusion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0460 2012 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks