AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P0440 2000 Toyota Echo

P0440 2000 Toyota Echo Code - Evaporative Emission Control System Malfunction

- Code Popularity: 10,488 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0440 2000 Toyota Echo?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Missing or loose fuel cap
  • Incorrect fuel filler cap used
  • Fuel filler cap remains open or fails to close
  • Foreign matter caught in fuel filler cap
  • EVAP canister or fuel tank leaks
  • EVAP system hose leaking
  • Fuel tank leaking
  • Vapor pressure sensor
  • ECM
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P0440 2000 Toyota Echo?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0440 2000 Toyota Echo Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0440 2000 Toyota Echo code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Malfunction is detected when EVAP control system has a leak, EVAP control system does not operate properly.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • A noticeable fuel odor may result from fuel vapor release

Code P0440 2000 Toyota Echo Description

The Engine Control Module (ECM) tests the Evaporative Emission (EVAP) system for the following conditions:
- Large and small leaks
- Excess vacuum
- Purge flow during non-commanded conditions
- Fuel Level and Fuel Pressure sensor faults
- EVAP Purge and Vent Valve faults
The ECM monitors the Fuel Tank Pressure sensor in order to determine the level of vacuum/pressure in the EVAP system. The ECM commands both the EVAP Purge Solenoid and the EVAP Vent Valve ON when the conditions are met in order to apply an engine vacuum to the EVAP system. The ECM commands the EVAP Purge Solenoid OFF once the system has reached a predetermined level of vacuum. This test verifies if a vacuum can be achieved in the EVAP system. Failure to develop a vacuum may be caused by a large leak or a restriction.
OBDII Code P0440 2000 Toyota Echo - Evaporative Emission Control System Malfunction - AutoCodes.com
P0440 2000 Toyota Echo Code - Evaporative Emission Control System Malfunction

Need More Information on the Code?

Need more information on how to fix the P0440 2000 Toyota Echo code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0440 2000 Toyota Echo code diagnosed by a professional: Find a repair shop in your area

Code P0440 2000 Toyota Echo comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0440 2000 Toyota Echo code? Have you replaced any parts?
Any information is appreciated. Thanks