P0410 GMC - Secondary Air Injection System Malfunction
- Faulty Air Pump inoperative
- Air bypass solenoid harness is open or shorted
- Air bypass solenoid circuit poor electrical connection
- Air bypass solenoid leaking/blocked or stuck open/closed
- Air diverter valve leaking/blocked or stuck open/closed
There is a factory service bulletin for the following GMC Models:
1999-2001 GMC Jimmy
GMC Factory Service Bulletin OBDII Code P0410
- Engine hesitation
An air pump is used on the vehicle to lower tail pipe emissions on start-up. The Powertrain Control Module (PCM) grounds the Air pump relay control circuit which energizes the Air pump. The PCM also grounds the Air combination valve vacuum control solenoid circuit, which energizes the Air vacuum control solenoid. Vacuum is then applied to both Air combination valve diaphragms which opens the shut off valves. The PCM enables both circuits simultaneously when Air system operations id desired. When the AIR system is active, then Air pump forces fresh air into the exhaust stream in order to accelerate catalyst operation. The AIR combination valves replace the conventional check valves. When the AIR system is inactive the shut off valves prevent air flow in either direction.
Where is the air injection pump located on a 2000 pontiac firebird?...
My emissions test failed. Put in a mass air flow sensor from a 2001 GM aurora, part was clean, not ...
po410 code on gmc envoy pump is working fuse is ok relay is ok new air pump hoses whats next?...
I pulled the hose from the diverter valve. The hose from the pump is not pushing/blowing any air. ...
I hope I can get some help on this and I apologize if its repetitive. I am new here, PO410 code ke...
Any information is appreciated. Thanks