AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P0356 Toyota

P0356 Toyota Code - Ignition Coil 6 Primary/Secondary Circuit

- Code Popularity: 47,896 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0356 Toyota?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Ignition Coil 6
  • Ignition Coil 6 harness is open or shorted
  • Ignition Coil 6 circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P0356 Toyota?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0356 Toyota Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0356 Toyota code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine may be harder to start
  • Engine hesitation
  • Rough engine idle

Code P0356 Toyota Description

A Direct Ignition System (DIS) is a 1-cylinder ignition system in which each cylinder is ignited by one ignition coil assembly and one spark plug is connected to the end of each secondary wiring. A powerful voltage, generated in the secondary wiring, is applied directly to each spark plug. The spark of the spark plugs passes from the center electrode to the ground electrode.
The Engine Control Module (ECM) determines the ignition timing and transmits the ignition (IGT) signals to each cylinder. Using the IGT signal, the ECM turns the power transistor inside the igniter on and off. The power transistor, in turn, switches the current supplied to the primary coil on and off. When the current to the primary coil is cut off, a powerful voltage is generated in the secondary coil. This voltage is applied to the spark plugs, causing them to spark inside the cylinders. As the ECM cuts the current to the primary coil, the igniter sends back an ignition confirmation (IGF) signal to the ECM for each cylinder ignition.
If the ECM does not receive any IGF signals despite transmitting the IGT signal, it interprets this as a fault in the igniter and stores a Diagnostic Trouble Code (DTC).

OBDII Code P0356 Toyota - Ignition Coil 6 Primary/Secondary Circuit - AutoCodes.com
P0356 Toyota Code - Ignition Coil 6 Primary/Secondary Circuit

Need More Information on the Code?

Need more information on how to fix the P0356 Toyota code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0356 Toyota code diagnosed by a professional: Find a repair shop in your area

Code P0356 Toyota comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0356 Toyota code? Have you replaced any parts?
Any information is appreciated. Thanks