AutoCodes.com | All About OBDII Engine Codes
AutoCodes - BMW - P0344 BMW

P0344 BMW Code - Camshaft Sensor 'A' Synchronization

- Code Popularity: 24,461 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0344 BMW?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Camshaft Position Sensor
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection
  • Faulty starter motor
  • Starting system circuit
  • Dead (Weak) battery
⚠ Does your BMW have Safety Recalls? → Check here

How to Fix the DTC P0344 BMW?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Sensor 'A' is Intake sensor.

Search for P0344 BMW Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0344 BMW code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Camshaft position sensor 'A' circuit intermittent bank 1 or snigle sensor

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall

Code P0344 BMW Description

The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.

OBDII Code P0344 BMW - Camshaft Sensor 'A' Synchronization - AutoCodes.com
P0344 BMW Code - Camshaft Sensor 'A' Synchronization

Need More Information on the Code?

Need more information on how to fix the P0344 BMW code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0344 BMW code diagnosed by a professional: Find a repair shop in your area

Code P0344 BMW comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0344 BMW code? Have you replaced any parts?
Any information is appreciated. Thanks