P0341 CHEVROLET - Camshaft Position Sensor 'A' Circuit Range/Performance
- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery
- Possible lack/loss of power
- Engine may stall while driving
The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.
Funde. Las. Bujias...
Where is the sensor located? Repair tips?...
I'm getting both P0339 and P0341 error codes. Could it be a bad battery?...
esposible que el po 341 cuando aselero el corro no selera y falla en la condusion porno aseleral...
Have a 2002 trailblazer LS. I replace crankshaft selenoid and camshaft position sensor previous code...
Any information is appreciated. Thanks