P0339 DODGE - Crankshaft Position Sensor Intermittent
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery
- Lack/Loss of Power
- Engine Stall
The Crankshaft position sensor also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module(ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
have a 2009 Dodge caravan 3.3l started misfiring. showed code p0302. i changed spark plugs, then ...
2003 dodge neon, I had a p0304 (cylinder 4 misfire) so I changed plugs/wires/coil, still jumpy, so ...
have code p0339 code sets,at high throttle seems after jerks engine light comes on with p0339 code t...
help i put new crank shaft censor new coal pack new ing molg - new computer still no fire to the dis...
My 2008 dodge caravan p0039 code is still coming up and I'm having all the same symptoms after check...
Any information is appreciated. Thanks