P0335 HONDA - Crankshaft Position Sensor 'A' No Signal
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery
- Possible lack/loss of Power
- Engine may stall while driving
The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module(ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
P0335 2009 HONDA ACCORD
P0335 2010 HONDA ACCORD
P0335 1996 HONDA CIVIC
P0335 1997 HONDA CIVIC
P0335 1998 HONDA CIVIC
P0335 1999 HONDA CIVIC
P0335 2000 HONDA CIVIC
why will car run with crank sensor unplugged its a new crank sensor...
I have a 2000 Honda Accord with the check engine on and this is the code P0335 what can be the possi...
One day my vehicle threw a CEL code P0335 and I checked it and installed a new crankshaft position s...
Any information is appreciated. Thanks