AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Acura - P0335 Acura

P0335 Acura Code - Crankshaft Position Sensor No Signal

- Code Popularity: 21,993 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0335 Acura?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Crankshaft Position Sensor (CKP)
  • Crankshaft Position Sensor harness is open or shorted
  • Crankshaft Position Sensor circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)
⚠ Does your Acura have Safety Recalls? → Check here

How to Fix the DTC P0335 Acura?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Sometimes and in some models, low battery voltage or a weak starter can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replace the battery.





User Submitted Video

Search for P0335 Acura Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0335 Acura code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall

Code P0335 Acura Description

The Crankshaft Position (CKP) Sensor detects injection/ignition timing for each cylinder and engine speed. The CKP sensor consists of a rotor and a semiconductor that detects the rotor position. When the engine starts, the rotor turns, and the magnetic flux in the semiconductor device changes. The magnetic flux changes are converted into pulsing signals to the Powertrain Control Module (PCM). If no pulsing signals from the CKP sensor are detected, the PCM detects a malfunction and stores a Diagnostic Trouble Code (DTC).

OBDII Code P0335 Acura - Crankshaft Position Sensor No Signal - AutoCodes.com
P0335 Acura Code - Crankshaft Position Sensor No Signal

Need More Information on the Code?

Need more information on how to fix the P0335 Acura code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0335 Acura code diagnosed by a professional: Find a repair shop in your area

Code P0335 Acura comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0335 Acura code? Have you replaced any parts?
Any information is appreciated. Thanks