AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P0222 Toyota

P0222 Toyota Code - Throttle / Pedal Position Sensor / Switch 'B' Circuit Low Input

- Code Popularity: 15,393 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0222 Toyota?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Throttle Position Sensor (built into Throttle Body Assembly)
  • Throttle Position Sensor circuit is open or shorted
  • Throttle Position Sensor poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P0222 Toyota?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Quite a frequent problem with Toyota models. Before replacing any parts, try cleaning the throttle body and resetting the code. If the code comes back, it will be necessary to replace the Throttle Body Assembly.





User Submitted Video

Search for P0222 Toyota Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0222 Toyota code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • No throttle response

Code P0222 Toyota Description

The throttle position sensor is mounted on the throttle with motor body assembly and detects the opening angle of the throttle valve. This sensor is a non-contact type sensor. It uses Hall-effect elements in order to yield accurate signals even in extreme driving conditions, such as at high speeds as well as very low speeds.
As the valve closes, the sensor output voltage decreases and as the valve opens, the sensor output voltage increases. The Engine Control Module (ECM) calculates the throttle valve opening angle according to these signals and controls the throttle actuator in response to driver inputs. These signals are also used in calculations such as air-fuel ratio correction, power increase correction, and fuel-cut control.
The ECM uses the throttle position sensor to monitor the throttle valve opening angle. There are several checks that the ECM performs to confirm the proper operation of the throttle position sensor.
This sensor transmits two signals, if the output voltage difference between the two signals deviates from the normal operating range, the ECM interprets this as a malfunction in the throttle position sensor. The ECM illuminates the MIL and stores the Diagnostic Trouble Code (DTC).

OBDII Code P0222 Toyota - Throttle / Pedal Position Sensor / Switch 'B' Circuit Low Input - AutoCodes.com
P0222 Toyota Code - Throttle / Pedal Position Sensor / Switch 'B' Circuit Low Input

Need More Information on the Code?

Need more information on how to fix the P0222 Toyota code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0222 Toyota code diagnosed by a professional: Find a repair shop in your area

Code P0222 Toyota comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0222 Toyota code? Have you replaced any parts?
Any information is appreciated. Thanks