P0190 FORD - Fuel Rail Pressure Sensor Circuit Malfunction
- Faulty Rail Pressure (FRP) Sensor
- FRP harness is open or shorted
- FRP circuit poor electrical connection
- Faulty Fuel Pump
- Engine will not start
The FRP sensor is a diaphragm strain gauge device. The FRP sensor measures the pressure difference between the fuel rail and atmospheric pressure. The FRP sensor nominal output varies between 0.5 and 4.5 volts, with 0.5 volts corresponding to 0 MPa (0 psi) gauge and 4.5 volts corresponding to 26 MPa (3771 psi) gauge. The sensor can read vacuums and may lower the output voltage to slightly below 0.5 volts. This condition is normal and is usually the case after several hours of cold soak before the vehicle dome light is turned on. The FP module is energized at the same time the dome light is commanded on. A disabled or malfunctioning dome light does not affect the FP module control.
The FRP sensor is located on the fuel rail, and provides a feedback signal to indicate the fuel rail pressure to the Powertrain Control Module (PCM). The PCM uses the FRP signal to command the correct injector timing and pulse width for correct fuel delivery at all speed and load conditions. The FRP sensor, along with the fuel volume regulator (part of the fuel injection pump), form a closed loop fuel pressure control system. An electrically faulted FRP sensor results in the deactivation of the fuel injection pump. Fuel pressure to injectors is then provided only by the FP module. When the fuel injection pump is de-energized and the injectors are active, the fuel rail pressure is approximately 70 kPa (10 psi) lower than FP module pressure due to the pressure drop across the fuel injection pump. Thus, if the FP module pressure is 448 kPa (65 psi), then the fuel rail pressure would be approximately 379 kPa (55 psi) if the injectors are active.
P0190 1998 FORD F150
P0190 1999 FORD F150
P0190 2000 FORD F150
P0190 2001 FORD F150
P0190 2002 FORD F150
P0190 2003 FORD F150
P0190 2006 FORD FUSION
P0190 2007 FORD FUSION
P0190 2008 FORD FUSION
P0190 2009 FORD FUSION
P0190 2010 FORD FUSION
P0190 2011 FORD FUSION
P0190 2012 FORD FUSION
I have a 1998 Ford Escort @ 111,500 miles, 2.0 L motor. It works fine in the past. However, today, w...
HI, I´m from Venezuela. I need the fuel rail sensor pressure. Do you know the number part? I want t...
where is sensor located...
Why does my engine not want to start after it has reached operating temperature? I've changed the fr...
Any information is appreciated. Thanks