P0157 CHEVROLET - HO2S Circuit Low Voltage Bank 2 Sensor 2
- Rear Heated Oxygen Sensor Bank 2 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 2 circuit poor electrical connection
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks
- High Fuel Consumption
- Excessive Smoke from Exhaust
The Powertrain Control Module (PCM) supplies a voltage of about 450 mV between the HO2S high and low signal circuits. The oxygen sensor varies the voltage over a range from about 1,000 mV when the exhaust is rich, down through about 10 mV when the exhaust is lean.
The PCM monitors and stores the heated oxygen sensor (HO2S) voltage information. The PCM evaluates the HO2S voltage samples in order to determine the amount of time the HO2S voltage was out of range. The PCM compares the stored HO2S voltage samples taken within each sample period and determines if majority of the samples are out of the operating range.
2004 CHEVROLET SILVERADO 5.3L "T" switched sensors from side to side still the P0157 watch sensor w...
**hello i changed both cat conv and all four sencers .engine light still came on then i replaced the...
where is no 2 bank 2 o2 sensor located on truck and what part is recommended to be replaced...
Any information is appreciated. Thanks