AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Mitsubishi - P0068 Mitsubishi

P0068 Mitsubishi Code - Manifold Absolute Pressure/Mass Air Flow Sensor - Throttle Position Correlation

- Code Popularity: 23,517 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0068 Mitsubishi?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Mass Air Flow (MAF) sensor
  • Large vacuum leak
  • Leaking air duct system
  • Mass Air Flow (MAF) poor electrical connection
  • Manifold Absolute Pressure (MAP) poor electrical connection
  • Faulty Manifold Absolute Pressure (MAP) sensor
  • TP sensor not seated properly
  • Faulty Throttle Position (TP) sensor
⚠ Does your Mitsubishi have Safety Recalls? → Check here

How to Fix the DTC P0068 Mitsubishi?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0068 Mitsubishi Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0068 Mitsubishi code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The Powertrain Control Module (PCM) monitors operation rationality check by comparing sensed throttle position to mass air flow readings

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of power
  • Engine rough idle

Code P0068 Mitsubishi Description

The Powertrain Control Module (PCM) monitors a vehicle operation rationality check by comparing Throttle Position (TP) to Mass Air Flow (MAF) readings. If, during a self-test, the comparison of the TP sensor and MAF sensor readings are not consistent with the calibrated load values, the test fails and a diagnostic trouble code is stored in continuous memory.

OBDII Code P0068 Mitsubishi - Manifold Absolute Pressure/Mass Air Flow Sensor - Throttle Position Correlation - AutoCodes.com
P0068 Mitsubishi Code - Manifold Absolute Pressure/Mass Air Flow Sensor - Throttle Position Correlation

Need More Information on the Code?

Need more information on how to fix the P0068 Mitsubishi code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0068 Mitsubishi code diagnosed by a professional: Find a repair shop in your area

Code P0068 Mitsubishi comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0068 Mitsubishi code? Have you replaced any parts?
Any information is appreciated. Thanks