AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - C1220

C1220 Code - Brake Pressure Sensor Supply Voltage Circuit High

- Code Popularity: 9,543 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC C1220?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Electronic Brake Control Module (EBCM)
  • Electronic Brake Control Module harness is open or shorted
  • Electronic Brake Control Module circuit poor electrical connection
  • Faulty Starter/Generator Control Module
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC C1220?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for C1220 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the C1220 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Anti-Lock Brake System (ABS) Warning Light ON
  • Engine Light ON (or Service Engine Soon Warning Light)

Code C1220 Description

The Electronic Brake Control Module uses inputs from the Electronic Brake Control Brake Pedal Position Sensor to determine when the brake is applied and how much force is used. The Electronic Brake Control Module monitors when the driver's foot is on the brake and locks the offset. The offset is locked when three out of the four inputs indicate the brake pedal is applied. The four inputs are brake pedal travel 1, brake pedal travel 2, master cylinder pressure sensor, and brake pedal position sensor. These inputs are used to determine the driver's braking intent which is used to control the amount of pressure applied to the wheels.
Brake pressure sensor information is communicated from the Electronic Brake Control Module (EBCM) to the Hybrid Control Processor (HCP). This information is used to schedule regenerative braking and engine autostops.
The Diagnostic Trouble Code (DTC) will be set when the Engine Control Module (ECM) detects a corrupted data message from the Electronic Brake Control Module.

OBDII Code C1220 - Brake Pressure Sensor Supply Voltage Circuit High - AutoCodes.com
C1220 Code - Brake Pressure Sensor Supply Voltage Circuit High

Need More Information on the Code?

Need more information on how to fix the C1220 code? Get Access to Factory Service Manuals

Information for Specific Makes

Need Help with the Code?

Get the C1220 code diagnosed by a professional: Find a repair shop in your area

Code C1220 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the C1220 code? Have you replaced any parts?
Any information is appreciated. Thanks